Victor Speed Controller (5-choices)

P/N: VICTOR

The Victor speed controllers are specifically engineered for robotic applications. Their high current capacity, low voltage drop, and peak surge capacity make the Victor ideal for drive systems while its braking options and precise control meet the demanding needs of arms and lift systems.

High current capacity.
Low voltage drop.
12V, 24V, 36V, and 48V options.

1 Review(s) | Add Your Review

In Stock

Starting at: $89.99

Price as configured: $0.00

Add to Wishlist

Victor Speed Controllers * Qty:

12V Victor 884 + 12V Fan +$89.99
24V Victor 883 + 12V Fan +$149.95
24V Victor 883 + 24V Fan +$149.95
36V Victor 36HV + 24V Fan +$199.95
48V Victor 48HV + 24V Fan +$199.95

Victor Speed Controller Add-Ons

x 3-Wire Extension Cable 12" (4-pack) +$19.95
x 3-Wire Extension Cable 24" (4-pack) +$19.95
x 3-Wire Extension Cable 36" (4-pack) +$19.95
x PWM Signal Driver +$14.95

* Required Fields

Price as configured: $0.00

Add Items to Cart Qty:

You may also be interested in the following product(s)

Product Name	P/N:	Availability	Price	Qty
Replacement Victor Fans (3-choices)		In stock.

Selection Chart

	Victor 884	Victor 883	Victor 885	Victor 36HV	Victor 48HV
Nominal Voltage	12V	24V	24V	36V	48V
Min/Max Voltage*	6-15V	6-30V	6-30V	12-42V	12-60V
Continuous Current	40A	60A	120A	120A	90A
Surge Current (2 sec)	-	100A	200A	250A	200A
Surge Current (1 sec)	-	200A	300A	275A	200A
PWM Output Chop Rate	120 Hz	2 KHz	120 Hz	120 Hz	120 Hz
Minimum Throttle	3%	10%	3%	3%	3%

* Min/Max voltage does not apply to the fan.

12V 884 Fan:Voltage Range: 6V to 16V
12V Rotron:Voltage Range: 6V to 16V
24V Rotron:Voltage Range: 16V to 30V

Technical Specifications

Downloads & Docs	Victor 883 / 885 Users Guide Victor 884 Users Guide Installation Guide
Battery In	Power Connector: 6-32 Screw Terminals (Maximum Screw Torque - 5 in*lbs) Do not reverse the input polarity on a Victor. Doing this will permanently damage the unit and void the warranty.
Inputs	Use a standard non-shrouded 3-wire cable. Standard R/C Type PWM (Pulse Width Modulation) PWM Input Pulse: 1 - 2 ms PWM Input Rate: 15 - 30 ms The red wire (center pin) on the 3-wire cable connected to the Victor is an open circuit. There is no reason to disconnect the red wire in the cable. The Victor does not source or draw power on the red wire. Use a PWM Signal Driver to ensure the signal from your receiver is Victor compatible. A PWM Signal Driver is not needed with IFI Control Systems, some receivers, and some mixers.
Outputs	Power one motor with variable speed forward, reverse, or off. No. Our Speed Controllers can NOT be used with Brushless motors.